This code should correspond to the “Electronic Design Document Notice” checksumto indicate the need to burn The recorded software is correct.
Check the software checksum (Buffer Checksum): After the software is loaded, a four-digit checksum will appear after the Buffer Checksum. 
Load the software to be burned: Click the menu “File”, select “Load File To Programmer Buffer”, then select the software click “Open”, then select “00”, and click OK. Select the IC Part No: The IC Part No produced by the company, click “Run”after selecting the IC Part No l. If you want to select a jumper for the programming socket at this time, follow the computer’s prompt to jumper and jumper the line, Then click “OK”. If there is no jumper on the programming socket, it will enter the programming interface directly. Then select the brand corresponding to the IC to be burned, and then click “OK”. After the program startup screen appears, click the “Device”menu to call up the IC brand selection table. Run the programming software: Double-click the “GANG-08″with the mouse (different programming sockets correspond to different burning software). Connect the programmer cable first,install the corresponding IC socket into the writer socket, and turn on the computer and the programmer.
0 kommentar(er)
